Rocal GALA Manuel Des Caracteristiques, Installation Et Fonctionnement page 12

6. Excessive draft
PROBLEM
7. Poor draft
7. CE INFORMATION
The CE label is located under the appliance. This label contains technical data and OF number. (This number can
also be found in the guarantee).
THIS NUMBER IS ESSENTIALFOR ORDERING SPARE PARTS.
CAUTION:
- All tests are carried out in observance of Regulations
UNE-EN13240:2002-A2:2005-AC: 2006-A2:2005/AC: 2007 "Stoves that use solid fuels –
Requirements and test methods".
- The review of the equipment, the installation and ducts must be carried out by a professional.
- In case of doubt regarding the described herein, please contact your Rocal dealer.
- FAILURE TO COMPLY WITH THE OBLIGATIONS DESCRIBED HEREIN OR IMPROPER HANDLING OF THE EQUIPMENT SHALL EXONERATE
THE MANUFACTURER OF ANY LIABILITY.
Incorrect duct
Combustion control registers in the wrong position
CAUSE
Incorrect duct
Duct dirtiness
Duct servicing
- Excessive length
- Check Depression
- Incorrect diameter
- Check door gasket
SOLUTION
Open the primary and secondary register following the
steps outlined in the manual. Should this not have an
effect, check that the flue duct is clean; if it is not clean,
contact a professional to clean this. If the problem persists
contact your dealer.
Remove upper baffle plate following steps "E.10", "E.11"
and "D.26", "D.27".
11