Ancona TORNADO ISLAND III 36 Mode D'emploi page 11

Step 3: Venting
• Fix the damper on the top vent of hood with screws. (See Fig. #3)
• Let the ducting pipe go inside through the hole from the ceiling. (See Fig. #4)
• Measure the length of 6`` round metal duct required from the dampler / duct connector to the ductwork
rough-in in the ceiling. Connect the duct to the damper / duct connector and seal with duct tape.
Fig # 3
Step 4: Electrical
• Use the supplied `S` hook to hold up the chimneys while feeding the electrical wires. (See Fig. #5)
• Remove the protective coating from the inner chimney. Carefully slide the inner chimney down into the outer
chimney. Slide the chimneys over the angle brackets.
• Feed the electrical wires up through the chimneys. (See Fig. #6)
• Connect the electrical wires to the wiring box on the ceiling bracket.
Fig # 5
INSTALLATION CONTINUE:
11
Fig # 4
Fig # 6