Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Bit flutes are sharp and
should be handled with
caution.
Always loosen and tight-
en the collet fan with off-
set wrench provided with attachment. Us-
ing collet fan as a gripping surface will damage
the collet fan and lead to personal injury or
property damage.
1. With tool unplugged, depress and hold shaft
lock in and rotate the Collet Fan and Shaft
shaft.
2. Use the Offset Wrench that came with your
ROTOSAW
SHAFT
LOCK
To change Collets, follow removal procedure
of DM10 from your RotoZip tool as outlined
DV-2610035986, Page: MUL (VAA), downloaded at: 2015.01.26_21:31:48, by PT-AC/MKP1-NA_Elise.Stockl
INSTALLING BITS
DM10 to loosen Collet Fan by turning coun-
ter clockwise.
3. Remove old bit and insert new bit:
a. RotoSaw – insert bit as far as possible
b. RZ Connect – insert bit so a maximum of
1.25"(32mm) extends beyond Collet Fan
Fan with Offset Wrench until bit is held se-
curely.
as a braking device to stop tool from rotat-
ing.
Fig. 7
COLLET
WRENCH
BIT
CHANGING COLLETS
above. Insert new collet and repeat assembly
procedure for your tool.
7
To prevent damage to
tool, never use shaft lock
RZ CONNECT
TOOL
SHAFT
LOCK
1.25"
(32mm)
Publicité
Table des Matières
