Bosch RotoZip DM10 Consignes De Sécurité/D'utilisation page 4

Disconnect
from the power source
before making any assembly, adjustments
or changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
1. To attach dust canister, slide Canister onto
dust port until Canister stop tabs are en-
gaged (Fig. 2).
Fig. 2
DUST
CANISTER
To empty canister:
1. Remove from tool and knock on a solid sur-
face to loosen dust (Fig. 3).
2. Hold canister and maintain a firm grip. Firm-
ly push upward on tab on corner of lid, and
remove from canister (Fig. 4). Knock excess
dust out of the microfilter, or remove dust
with your fingers or a soft brush. You may
Fig. 3
DV-2610035986, Page: MUL (VAA), downloaded at: 2015.01.26_21:31:48, by PT-AC/MKP1-NA_Elise.Stockl
Assembly
the plug
ments, make sure the chuck and any other
adjustment devices are securely tightened.
shift, causing loss of control, loose rotating
components will be violently thrown.
CANISTER ASSEMBLY
2. To remove dust canister, squeeze release
tabs on both sides of canister and pull away
from dust port (Fig. 2).
RELEASE
STOP
TABS
TABS
RELEASE STOP
TABS TABS
notice that all the dust may not come out
of the canister. This will not affect cutting
performance but will reduce dust collection
efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
Fig. 4
4
After changing bits or
making any adjust-
DUST
PORT
FAN
HOUSING