Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1. With tool unplugged, remove RotoSaw
Depth Guide, Collet Nut, and Collet accord-
ing to its instructions.
2. Install RotoSaw coupler as shown.
3. Install Collet according to diameter of bit to
be used.
4. Install Collet Fan by pressing collet lock but-
ton and rotating Collet Fan clockwise with
wrench provided. Do not fully tighten.
5. Install Fan Housing as shown. Dust Canis-
ter should be on right side of tool.
6. Secure Fan housing by installing Thumb-
screw (Red) that came with your RotoSaw
tool. Tighten firmly by rotating clockwise.
Fig. 5
THUMBSCREW
DV-2610035986, Page: MUL (VAA), downloaded at: 2015.01.26_21:31:48, by PT-AC/MKP1-NA_Elise.Stockl
ASSEMBLY ROTOSAW
7. To remove, loosen thumbscrew by rotating
counter clockwise and remove parts in re-
verse order.
ment without Fan Housing mounted. Oper-
ating DM10 without Fan Housing mounted
may result in personal injury.
set wrench provided with attachment. Us-
ing collet fan as a gripping surface will damage
the collet fan and lead to personal injury or
property damage.
ROTOSAW
COLLET
ROTOSAW
COUPLER
COLLET
FAN
FAN
HOUSING
5
Do not operate DM10
Dust Collection Attach-
Always loosen and tight-
en the collet fan with off-
COLLET
WRENCH
Publicité
Table des Matières
