Additional Information - Pioneer GM-D9605 Mode D'emploi

Appendix

Additional information

Specifications
Power source ............................. 14.4 V DC (10.8 V to 15.1 V
Grounding system ................... Negative type
Current consumption ............ 55 A (at continuous power,
Average current consumption
..................................................... 6 A (4 W)
Fuse ................................................ 30 A × 3
Dimensions (W × H × D) ... 315 mm × 60 mm ×
Weight .......................................... 3.2 kg (Leads for wiring not
Maximum power output ....... 150 W × 4 + 700 W (4 W),
Continuous power output ... 75 W × 4 + 350 W (at 14.4 V,
Load impedance ...................... 4 W (2 W to 8 W allowable)
Frequency response:
A/B CH:10 Hz to 50 kHz
SUB CH:10 Hz to 500 Hz
Signal-to-noise ratio ............... 94 dB (IEC-A network)
Distortion ..................................... 0.05 % (10 W, 1 kHz)
Low pass filter:
(A/B CH)
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct
(SW)
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct, –24 dB/oct
High pass filter:
(A/B CH)
Cut off frequency ........... 40 Hz to 500 Hz
Cut off slope ..................... –12 dB/oct
Bass boost:
(SW)
Frequency .......................... 50 Hz
Level ..................................... 0 dB to 18 dB
Gain control:
RCA ...................................... 200 mV to 6.5 V
Speaker .............................. 0.8 V to 16 V
Maximum input level / impedance:
RCA ...................................... 6.5 V / 25 kW
Speaker .............................. 16 V / 12 kW
16
En
allowable)
4 W)
200 mm
(1 ft. × 2-3/8 in. × 7-7/8 in.)
included)
200 W × 4 + 1 200 W (2 W)
(2 000 W TOTAL)
4 W)
200 W × 2 + 350 W (at
14.4 V, 4 W)
100 W × 4 + 600 W (at
14.4 V, 2 W)
CEA2006 Specifications
Power output ............................. 75 W RMS × 4 + 350 W x 1
S/N ratio ....................................... 75 dBA (reference: 1 W into
Notes
! Specifications and the design are subject to
modifications without notice.
! The average current consumption is nearly
the maximum current consumption by this
unit when an audio signal is input. Use this
value when working out total current con-
sumption by multiple power amplifiers.
RMS ( 4 W and ≦ 1 % THD
+N)
4 W)