Connections When Using The Speaker Input Wire; Solderless Terminal Connections - Pioneer GM-D9605 Mode D'emploi

Connecting the units
Three channel output (Stereo
bridge)
In the case of a bridge connection, connect
the speaker leads based on the figure shown
below.
3
1 Left
2 Right
3 Subwoofer output
Connections when using
the speaker input wire
Connect the car stereo speaker output wires
to the amplifier using the supplied speaker
input wire.
! Do not connect both the RCA input and the
speaker input at the same time.
1 Car Stereo
2 Speaker output
3 Speaker leads
White: Front left +
White/black: Front left *
Gray: Front right +
Gray/black: Front right *
Green: Rear left +
Green/black: Rear left *
Violet: Rear right +
Violet/black: Rear right *
4 Speaker input wire
To the SP INPUT (speaker input) terminal of
this unit.
Note
2
If speaker input wires from a head unit are con-
nected to this amplifier, the amplifier will automa-
tically turn on when the head unit is turned on.
When the head unit is turned off, the amplifier
turns off automatically. This function may not
work with some headunits. In such cases, please
use a system remote control wire (sold sepa-
rately). If multiple amplifiers are to be connected
1
together synchronously, connect the head unit
and all amplifiers via the system remote control
wire.
Solderless terminal
connections
! Since the wire will become loose over time,
it must be periodically inspected and tigh-
tened as necessary.
! Do not solder or bind the ends of the
twisted wires.
! Fasten while making sure to not to clamp
the insulating sheath of the wire.
! Use the supplied hexagonal wrench to
tighten and loosen the terminal screw of
the amplifier and use it to securely fasten
the wire. Be careful to avoid excessive tigh-
tening of this screw, which may damage
the wire.
Section
03
11
En