Connections When Using The Speaker Input Wire - Pioneer GM-D1004 Mode D'emploi

Connecting the units
4 RCA cables (sold separately)
5 Car stereo with RCA output jacks
Connections when using
the speaker input wire
Connect the car stereo speaker output wires
to the amplifier using the supplied SP input
cord.
1 INPUT SELECT (input select) switch
2 SP input cord
To signal input terminal of this unit.
3 Speaker cord
— White/black: Front SP, Left *
— White: Front SP, Left +
— Gray/black: Front SP , Right *
— Gray: Front SP, Right +
— Green/black: Rear SP, Left *
— Green: Rear SP, Left +
— Violet/black: Rear SP, Right *
1
2
3
4
— Violet: Rear SP, Right +
4 ISO connector
Note
If speaker input wires from a head unit are con-
nected to this amplifier, the amplifier will automa-
tically turn on when the head unit is turned on.
When the head unit is turned off, the amplifier
turns off automatically. This function may not
work with some head units. In such cases, make
sure that the front L channel is connected cor-
rectly. If the function still does not work, please
use a system remote control wire.If multiple am-
plifiers are to be connected together synchro-
nously, connect the head unit and all amplifiers
via the system remote control wire.
Section
03
9
En