Luminosity Modes; Constant Color Mode; Auto Modes - Ayrton IceColor 250 Manuel D'utilisation

Factory mode (Default Mode)
DMX address = 1
MODE = 4 channel
Dimmer = Inverted
Light Mode = Entertainment
Constant Color = OFF
AUTO mode = all OFF
Wireless DMX output = disable
Icecolor menu

LUMINOSITY Modes

This menu allow to adjust the luminosity of the device.
There are 2 distinct modes in ICECOLOR:
ENTERTAINMENT Mode
This Mode allow to gain the best from the device's light
output power, depending on the outdoor temperature
conditions. When the ICECOLOR is cold, the available
power is at a maximum. If the temperature increases
too much, the ICECOLOR will gradually reduce its
power to guarantee its thermal regulation. This Mode
is recommended for temporary events where the light
output of the ICECOLOR must be optimum.
ARCHITECTURAL Mode
This Mode guarantees a stability of the device's luminous
flux, in return for a less high luminous flux than for the
'Entertainment' Mode. This mode is recommended in the
context of fixed-place installations of the ICECOLOR where
the consistency of the flux is important. It is also advisable
to use this Mode in the case where the ICECOLOR is very
often set at values close to 100% of its power.

CONSTANT COLOR Mode

This menu allow to regulate the consistency of the colour
generated by the ICECOLOR.
This mode makes it possible to avoid the phenomenon
of a gradual deterioration in colour observed generally on
projectors equipped with LED light sources, which occurs
when the device heats.
This Mode can be activated or deactivated in the ICECOLOR,
which produces the following effects:
CONSTANT COLOR ON Mode
In this Mode, the device's internal software automatically
compensates for the phenomenon of the deterioration of
the colorimetry which occurs when the device becomes
hot with use, thus preserving the colours adjusted when
- option details
USER MANUAL
this was cold. In return, when the CONSTANT COLOR
Mode is activated, the device's general luminosity is
likely to reduce. This Mode is recommended when the
device is intended to light up a given target in a preset
colour (or with a slow change of colour) together with
other projectors of the same type for a long period. By
nature, this mode is particularly suited to the constraints
of Architectural lighting.
CONSTANT COLOR OFF Mode
The function is deactivated and no compensation of
colorimetry depending on the temperature is activated.
The quantity of light available with ICECOLOR is maximum
when this function is deactivated, but the nature of the
colours configured on the device is likely to deteriorate
when the device heats (this is because the Red LEDs
significantly lose efficiency as the temperature increases).
This traditional mode is recommended for event lighting
and the majority of temporary lighting uses, where the
maximum quantity of light is favoured.

AUTO Modes

This menu offers several functionalities which allow to use the
ICECOLOR without DMX lighting controller.
It is possible to drive the ICECOLOR directly from its integrated
control panel, while using one of the two integrated AUTO
Modes. It is therefore possible to configure the projector
light output to a static colour, or also to activate a variation
of a pre-recorded dynamic colour whose transition speed is
adjustable (via the CONFIG menu).
The triggering of one of these AUTO Modes can be
parameterised (via the ACTIVATE Menu).
CONFIG
This menu allow to adjust the light levels of the STATIC
AUTO Mode, or to regulate the passing speed of the
DYNAMIC AUTO Mode.
Important: the last Autonomous Mode modified or
selected by the user will be triggered by the ACTIVATE
Menu.
STATIC Mode
This menu makes it possible to adjust a static colour on
the device.
The intensity of each colour present on the device
can be adjusted separately and a general Dimmer
makes it possible to adjust the general level of the
device's luminosity. The principle of this menu involves
successively adjusting the level of each of these colours
of available LEDs in order to obtain the final colour
desired and then to adjust the general Dimmer.
DYNAMIC Mode
This menu allow to adjust the passing speed and the
9