Braun Syncro System Logic 7680 Mode D'emploi page 6

6
press again:
– to display the key part number for shaver foil
and cutter block
hold for 3 secs:
– to run a display demo
The «SmartLogic» inside your shaver will detect when the
shaver needs to be cleaned (refer to paragraph «Manual
cleaning» or to separate «Clean&Charge» use instructions).
To reset the display, push the info key.
The «SmartLogic» inside will recognize when the shaver
has to be lubricated (refer to paragraph «Manual cleaning»
or to separate «Clean&Charge» use instructions). To reset
the display, push the info key.
The shaver cannot be charged if the environmental
temperature is too low (<0 °C) or too high (>55 °C).
Allow the shaver to remain for some time at room
temperature for optimal charging conditions.
No display: The rechargeable battery is completely
discharged and has to be recharged.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts
to every contour of your face.
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose).
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Shaving with the cord
If the rechargeable battery is discharged, you may also
shave with the shaver connected to the mains via the
power supply cord set.
(If the shaver does not run immediately, charge it with the
switch on position «0» for approx. 1 minute.)