Before First Use; Using The Appliance; Preheating The Espresso Machine - MPM MKW-06M Notice D'utilisation

BEFORE FIRST USE

1. Remove the espresso machine from the packaging. Remove all plastic bags, fillers, safety
locks and packaging labels.
2. Inspect the espresso machine for damage which may have been caused in transport. If you
suspect that the espresso machine is damaged, do not use it. Consult the seller.
3. Verify that your power mains match the nameplate ratings of the espresso machine.
4. To ensure the best flavour of the coffee, carry out the steaming procedure. Follow these steps:
 Remove the water tank (15) from the espresso machine, pour about 1 litre of cold drink-
ing water, and do not exceed 1.7 litres (the MAX level). Place the water tank back in the
espresso machine.
 Place the filter (16) or (17) in the filter holder (18) and attach the filter holder to its receptacle,
and secure. The filter must be empty. Do not add any coffee yet.
 Place the drip tray (13) in the drip tray seat (11) and place the drip tray grate (12) on the tray.
Place an empty cup on the grate. Make sure that the steam level knob (3) is set at its the
uppermost position.
CAUTION! The espresso machine does not come with any coffee cups. Use your own cups.
 Plug the espresso machine to a mains outlet and start water heating by pressing (4). The
switch LED will start flashing. Turn on the pressure switch (5). The water heater will be
primed and vented of air. Once the water is hot, the hot water switch LED will be steadily
on. Press the pressure switch (5): hot water will start filling the cup. When the hot water
switch LED (4) starts flashing, turn off the pressure switch and empty the cup. When the
hot water switch LED (4) is steadily on again, repeat. Do this 2 times more.
CAUTION! When the water pump is turned on for the first time with the pressure switch, unusual sound may
be heard which will stop in approximately 30 seconds. This is the water pump being vented and it is perfectly
normal.

USING THE APPLIANCE

PREHEATING THE ESPRESSO MACHINE

In order to enjoy the best coffee aroma, heat up the filter holder with the filter in it and the cup
by following these steps:
1. Remove the water tank and fill it with cold drinking water. Do not pour in more than the MAX
level or less than the MIN level. Place the water tank back in the espresso machine.
2. Place the filter (16) or (17) in the filter holder (18) and attach the filter holder to its recepta-
cle (10), and secure. Do not put coffee in the filter yet.
3. Place the drip tray (13) in the drip tray seat (11) and the grate (12) on the tray. Put a coffee cup
on the grate.
4. Make sure that the steam level knob (3) is set at its uppermost position (closed). Plug the
espresso machine to the mains.
5. Start water heating by pressing (4). The switch LED will start flashing. Once the water is hot,
the hot water switch LED will be steadily on. Press the pressure switch (5): hot water will start
filling the cup. Turn off the pressure switch (5) after 20 seconds. The espresso machine, the
filter holder and the filter are now preheated.
15