Toto Kiwami Renesse TB170DD Manuel D'installation Et D'utilisation page 4

3. Unscrew and remove plug
cover.
4. Affix the seal packing and
escutcheon to valve body.
5. Use the large Allen wrench
to install the spout with set
screw, tighten firmly.
6. Use the small Allen wrench
to install the handles with
set screw, tightening firmly.
CaUTion
• Do not overtighten the
escutcheon; this can
damage tile.
• Make sure the spout,
knob, and escutcheon is
positioned properly in the
tile as shown in the figure.
• Make sure to correctly
position the hot and cold
handles as shown in the
figure.
insTaLLaTion PRoCeDURe
Allen wrench
Spout
Spout
Adapter
Seal packing
(small)
HOT
Close
Escutcheon
4
(large)
Set screws
Knobs
Open
Spout
Plug cover
Allen
wrench (small)
Escutcheon
(COLD)
Escutcheon
Adapter
Seal packing
(large)
COLD
Close
Open
Escutcheon