Abicor Binzel ABIPLAS WELD 100 POWDER W Mode D'emploi page 35

®
ABIPLAS WELD 100/150 POWDER W
BAL.0086 • 2021-08-19
1 Insert the blunt end of the tungsten electrode into
the back cap to a depth of about 5 mm.
2 Slide the centring ceramics over the tungsten
electrode.
3 Screw the back cap into the torch body from
above until reaching the end stop.
4 Unscrew the back cap one full turn anti-
clockwise.
5 Screw the plasma nozzle into the torch body and
tighten it using a switch key wrench.
6 Use the pivot of the alignment gauge to press the
tip of the tungsten electrode into the torch until the
front face of the alignment gauge lies flat against
the plasma nozzle.
7 Tighten the back cap.
8 Place the insulating ring on the torch body.
9 Place the distributor ring on the torch body and
screw it on until reaching the end stop.
10Screw on the powder nozzle and tighten it
manually using a switch key wrench.
11 Manually screw the gas nozzle onto the torch
body.
6 Putting into operation
EN - 13