Completing The Installation - MINN KOTA MKA-21 Mode D'emploi

Completing the Installation

1
ITEM(S) NEEDED
a. Mount the motor onto the Inner Plate.
b. Slide the Handle Assembly (Item #6) into the rod
holes of the Outer Plate. Slide the Hair Clip Pin
(Item #10) through the Lock Pin to secure the
Handle Assembly.
c. Your motor is now mounted. Always make sure the
Handle Assembly is fully inserted and retained by
the Hair Clip Pin.
NOTICE:
A padlock can be used in place of the
Hair Clip Pin to prevent motor theft.
For warranty information, please visit
minnkotamotors.com
Part #2374917
#6 x 1
minnkotamotors.com.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
#10 x 1
1a
Inner Plate Inner Plate
1b
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
ECN 41450
Outer Plate Outer Plate
Rod Holes Rod Holes
Hair Clip Hair Clip
Handle Handle
Pin Pin
Assembly Assembly
©2021 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev H 04/21