MINN KOTA MKA-21 Mode D'emploi page 3

INSTALLATION
Positioning the Bracket
1
ITEM(S) NEEDED
a. Take the Outer Plate (Item #4), Inner Plate
(Item #2), Handle Assembly (Item #6) and Pad
Lock Pin (Item #8). Assemble the bracket and place
it on the deck of the boat.
b. Determine if the motor will be mounted on the Port
or Starboard side of the bow and if the Handle
Assembly will release inboard or outboard. Be sure
that the Handle Assembly will not encounter any
obstructions on the bow of the boat and can be
completely pulled out to release the plates when
mounted. The bracket is designed so that the handle
can be positioned on either side to accommodate
clearances and personal preference. The side of the
bracket that the Handle Assembly is used on will
determine which side the Padlock Pin (Item #8) will
be installed on.
NOTICE:
Make sure that the motor will not
encounter any obstructions when positioning
the motor on and off the composite bracket. The
exact placement of the motor and bracket, when
mounting, may vary depending on the boat, boat
deck, and which base extrusion or bracket the
bracket is being mounted to.
2
c. Once an orientation for the Handle Assembly is
selected, place the Padlock Pin into the Outer Plate
on that side, oriented so that the larger diameter
of the Pin is in the Outer Plate. Rotate the Pin so
that the hole in the Pin lines up with the hole in the
Outer Plate.
Outer Plate Outer Plate
3 | minnkotamotors.com
#4 x 1
1a
Outboard Outboard
1b
Padlock Pin Padlock Pin
#2 x 1 #6 x 1
Outer Plate Outer Plate
Handle Handle
Assembly Assembly
Positions Positions
Outboard Outboard
Port Port
Inboard Inboard
NOTICE:
The Lock Pin must be in place before installing
the Outer Plate to the motor.
Outer Plate Outer Plate
#8 x 1
Bow of Boat Bow of Boat
Handle Handle
Assembly Assembly
Positions Positions
Inboard Inboard
Padlock Pin Padlock Pin
Bow of Bow of
Boat Boat
Starboard Starboard
Padlock Pin Padlock Pin
©2021 Johnson Outdoors Marine Electronics, Inc.