MINN KOTA MKA-21 Mode D'emploi page 6

Installing the Outer Plate to a DeckHand 40
1
ITEM(S) NEEDED
a. Position the DeckHand 40 Davit and Base over the
Outer Plate (Item #4) and mount the Bracket using
only the four holes that are farthest Outboard.
The two holes closest inboard are not used to install
the Bracket.
b. Take four ¼" x 1½" Stainless Steel Screws
(Item #12) and insert them from the bottom of the
Outer Plate through the DeckHand 40. Secure each
Screw with a Flat Washer (Item #14) and a Nylock
Nut (Item #20).
Installing the Outer Plate to a Pontoon Hand Control Bracket
1
ITEM(S) NEEDED
a. Position the Pontoon Hand Control Bracket over the
Outer Plate (Item #4) and mount the Bracket using
only the four holes that are farthest Outboard.
The two holes closest inboard are not used to install
the Bracket.
b. Take four ¼" x 1½" Stainless Steel Screws
(Item #12) and insert them from the bottom of
the Outer Plate through the Pontoon Hand Control
Bracket. Secure each Screw with a Flat Washer
(Item #14) and a Nylock Nut (Item #20).
6 | minnkotamotors.com
#4 x 1 #12 x 4
1a
Inboard Inboard
#4 x 1 #12 x 4
1a
Inboard Inboard
#14 x 4
1b
Mounting Mounting
Holes Holes
DeckHand 40 DeckHand 40
Base and Davit Base and Davit
Outer Outer
Plate Plate
Outboard Outboard
#14 x 4
1b
Outboard Outboard
Mounting Mounting
Holes Holes
Flat Flat
Washer Washer
Outer Outer
Plate Plate
Inboard Inboard
©2021 Johnson Outdoors Marine Electronics, Inc.
#20 x 4
Outboard Outboard
Nylock Nut Nylock Nut
Flat Flat
Washer Washer
Stainless Stainless
Steel Screw Steel Screw
Inboard Inboard
#20 x 4
Pontoon Pontoon
Outboard Outboard
Hand Control Hand Control
Bracket Bracket
Nylock Nylock
Nut Nut
Stainless Stainless
Steel Screw Steel Screw