MINN KOTA MKA-21 Mode D'emploi page 5

3
ITEM(S) NEEDED
e. Align the Outer Plate with the Base Extrusion.
Position the Outer Plate so that the widest portion is
facing inboard.
f. Use six ¼" x 1½" Stainless Steel Screws (Item
#12), six Flat Washers (Item #14) and six Nylock
Nuts (Item #20) to fasten the Outer Plate to the
bottom of the base extrusion. The Screws should
pass from the bottom of the Outer Plate and then
through the Base Extrusion. Place a Flat Washer on
the end of each bolt and then secure each Screw
with a Nylock Nut.
g. Re-install both side covers. Secure the Screws using a
#3 Phillips Screwdriver.
5 | minnkotamotors.com
#12 x 6 #14 x 6 #20 x 6
3f
Outboard Outboard
Nylock Nylock
Nut Nut
Flat Flat
Washer Washer
Outer Outer
Plate Plate
Stainless Stainless
Steel Screw Steel Screw
3g
Motor Base Motor Base
Extrusion Extrusion
Inboard Inboard
©2021 Johnson Outdoors Marine Electronics, Inc.