MINN KOTA MKA-21 Mode D'emploi page 7

Installing the Outer Plate to an Ulterra
1
WARNING
Make sure that the Power Cables from the battery are
disconnected, or that the breaker, if equipped, is "off."
NOTICE:
A motor may weigh up to 65lbs. We
recommend having a second person help with
the installation.
a. Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor should be in the stowed position.
NOTICE:
Ulterra installation will use hardware that was
included with the Ulterra motor. The hardware needed
will be six Clipped Washers (#2201725) from the Ulterra
bag assembly (#2994917).
2
b. Using a #2 Phillips Screwdriver, remove the
Sideplates to access the Mounting Slots by removing
the two screws that hold each sideplate in place.
3
c. Under the Left Sideplate, the Extension Damper
obstructs access to the left front Mounting Hole.
d. Using a small Screw Driver, remove the two
5/16" e-clips holding the Extension Damper in
place. Once the e-clips are removed, slide the
Extension Damper off the Damper Pins to expose
the left rear Mounting Hole. Set the two e-clips
and Extension Damper in a safe place so they are
not misplaced before they are reassembled later in
the installation.
7 | minnkotamotors.com
Power Cables Power Cables
Deployed Deployed
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor before
it is mounted to the boat may cause injury.
2b
Right Side Right Side
plate plate
3c
E-clip E-clip
Extension Extension
Damper Damper
3d
E-clips E-clips
Stowed Stowed
2b
Left Sideplate Left Sideplate
E-clip E-clip
Mounting Hole Mounting Hole
Extension Extension
Damper Pins Damper Pins
Damper Damper
©2021 Johnson Outdoors Marine Electronics, Inc.