Parts Diagrams - DWT WS06-115 Notice Originale

tool out to the side of the operator, which can lead to
serious injuries appears.
Grinding (see fig. 6)
Grinding is applied for the rough and quick grinding of
metals, the processing of welding seams, etc. Select
the type of grinding disc depending on the work, which
you are going to implement.
• Install grinding disc as described above.
• Start the power tool, wait until the engine gains its
maximum speed and only after that smoothly bring
grinding disc to the surface processed.
• Holding the power tool at an angle of 10° to 15°
relating to the surface processed (see fig. 6) is
recommended. If this angle is less than recommended,
it will make controlling the power tool more difficult. If
this angle is more than recommended, the processing
quality will decrease and grooves will be left on the
billet surface.
• Make alternate-reciprocal movements applying
moderate pressure to the power tool. Excessive
pressure will not bring better results but it will overload
the engine and create the danger of destruction of
grinding disc, which can cause severe injuries.
Power tool maintenance /
preventive measures
Before carrying out any works on the power tool it
must be disconnected from the mains.
Cleaning of the power tool
An indispensable condition for a safe long-term
exploitation of the power tool is to keep it clean. During
The manufacturer reserves the possibility to introduce changes.
the long treatment of metal, current-conducting dust
can be accumulated inside the power tool. Regularly
flush the power tool with compressed air thought the
ventilation slots 3.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.dwt-pt.com.
• Categorically not to drop any mechanical impact on
the packaging during transport.
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging.
Recycle
disposing as waste.
Power tool, accessories and packaging should be
sorted for environment-friendly recycling.
The plastic components are labelled for categorized
recycling.
These instructions are printed on recycled paper
manufactured without chlorine.
English
12
Transportation
of the power tools
Environmental
protection
raw materials instead of