Pvvk-Sh636 Vent Kit - Empire Comfort Systems Mantis Instructions D'installation

1. Apply silicon to back of the vent adaptor plate. Line up the
vent adaptor plate with the sump assembly and secure with
three 6-32 x 1/2" flat head screws. See Figure 5.
2. Add silicon to the vent adaptor plate to seal screws. Press
the gasket into the vent adaptor plate. Ensure that the holes
line up and that there is no overlap. See Figure 6. Remove
excess caulk and wait at least five minutes for the silicon to
dry before continuing to the next step.
3. Insert the reducer into the vent cover plate as shown in Fig-
ure 7. The distance between the bottom of the reducer and
the interior of the vent cover plate is 1-1/16 inch. See Figure
8.
31793-3-1015
All manuals and user guides at all-guides.com

PVVK-SH636 VENT KIT

Figure 5
Figure 6
Figure 7
Figure 8
4. Place the vent cover plate over the vent adaptor plate as
shown in Figure 9. For proper plate alignment, see Figure
10.
Figure 10
Note: Use IPEX venting for exhaust.
5. Secure the vent cover plate to the vent adaptor plate with four
10 x 1/2" sheet metal screws (provided). See Figure 11.
CAUTION: To ensure a watertight seal, leave no more than a
1/8 inch gap between the vent cover plate and the vent adap-
tor plate flanges.
Figure 11
Figure 9
Page 13