Dell PowerConnect 54 Serie Guide De Mise En Route page 16

The Setup Wizard guides you through the initial switch configuration, and gets the system up and running
as quickly as possible. You can skip using the setup wizard and configure the switch manually through the
device CLI mode. Consult the PowerConnect 5400 Series User's Guide for assistance in configuring the
device using CLI.
The Setup Wizard configures the following fields.
• SNMP Community String and SNMP Management System IP address (optional)
• Username and Password
• Device IP address
• IP subnet mask
• Default Gateway IP address
The Setup Wizard displays the following information:
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch configuration,
and gets you up and running easily and quickly. You can also skip
the setup wizard, and enter CLI mode to manually configure the switch
if you prefer. You can exit the setup wizard any time by entering
{CNTRL+Z]. The system will prompt you with a default answer.
By pressing Enter, you accept the default value.
Would you like to skip the setup wizard? [Y/N] N
If you enter[Y], the Set-up wizard exits. If you do not respond within 60 seconds, the Set-up wizard
automatically exits and the CLI console prompt appears.
If you enter [N], the Set-up wizard provides interactive guidance through the initial device configuration.
NOTE:
You can exit the setup wizard at any time by entering [CNTRL+Z].
NOTE:
If you do not respond to any prompt within 60 seconds, the Set-up wizard automatically exits. And, none
of your changes are saved.
Wizard Step 1
The following information displays:
The system is not setup for SNMP management by default. To manage
the switch using SNMP (required for Dell Network Manager) you can:
• Setup the initial SNMP version 2 account now.
• Return later and setup the SNMP version account. (For more
information on setting up a SNMP version 2 account, see the user
documentation).
Would you like to setup the SNMP management interface now? [Y/N] Y
Enter [N] to skip to Step 2.
14
Starting and Configuring the Device