Pentair Pentek Solar Drive Hardware - Pentair PENTEK SOLAR DRIVE PSD15 Mode D'emploi

PENTAIR PENTEK
The Pentair Pentek Solar Drive controller consists of several components, as shown in Figure 5.
The unit has three wire glands: two large glands for a motor cable (left) and for solar PV array
(right), and one gland for data cables (middle), a float switch sensor or other optional sensor.
There is direct access to the power and signal terminals on the circuit board once the enclosure
door is removed.
The Pentair Pentek Solar Drive controller should be mounted on a wall or other vertical surface
using the back bracket (see Figure 5 below). On the back side of the unit there are two set screws
used to hang the unit on the back bracket. More detailed mounting instructions are shown below.
Back View
1
Fix the back bracket to the
support surface by inserting
three screws (not included)
through the 3 holes in the
back bracket
P1061 (06/06/19)
SOLAR DRIVE HARDWARE
*
Set Screw for Hanging the
Pentair Pentek Solar Drive to the Back Panel
2
Make sure both set screws
are used to hang the Pentair
Pentek Solar Drive onto the
back bracket
Figure 5: Pentair Pentek Solar Drive Hardware
Heatsink
Back Panel
(Wall Mount)
Wire
Glands
Front View
3
Mounted!
7