Hach NA5600 sc Na+ Mode D'emploi page 30

1. Put the SD card in the PC.
2. Download the latest software as follows:
a. Go to http://www.hach.com.
b. Search for "NA5600sc analyzer".
c. Select the "Downloads" tab. Scroll down to "Software/Firmware".
d. Click the link for the software download. Select Open. A Hach folder shows.
3. Copy the HACH folder to the SD card.
4. Remove the SD card from the PC.
5. Hold the SD card so that the label points to the right. Put the SD card in the SD card slot on the
analyzer. Refer to
6. Push menu, then select SD CARD SETUP > UPGRADE SOFTWARE.
7. When the installation is complete, push enter to reboot the analyzer.
8. Install the new measurement cycle script as follows:
a. Push menu, then select SD CARD SETUP > WORK WITH DEVICES > WRITE DEVICE
FILE.
b. When the installation is complete. set the power switch to off (down). Refer to
on page 3.
c. Wait 10 seconds, then set the power switch to on (up).
9. Remove the SD card from the analyzer.
10. Install the cover for the SD card slot to keep the environmental rating of the enclosure.
6.6 Install the latest HART module firmware
Install the latest HART module firmware on the analyzer.
Items to collect:
• SD card (2 GB or more)
• PC with SD card slot and internet access
1. Put the SD card in the PC.
2. Download the latest HART firmware as follows:
a. Go to http://www.hach.com.
b. Search for "NA5600sc analyzer".
c. Select the "Downloads" tab. Scroll down to "Software/Firmware".
d. Click the link for the HART module firmware download. Select Open. A Hach folder shows.
3. Copy the HACH folder to the SD card.
Note: The HART module firmware is the bin file in \HACH\Firmware\HART 0_32768.
4. Remove the SD card from the PC.
5. Hold the SD card so that the label points to the right. Put the SD card in the SD card slot on the
analyzer. Refer to
6. Push menu, then select SD CARD SETUP > UPGRADE SOFTWARE > NETWORK CARD.
7. When the installation is complete, push enter to reboot the analyzer.
8. Remove the SD card from the analyzer.
9. Install the cover for the SD card slot to keep the environmental rating of the enclosure.
30 English
Figure 11 on page 29.
Figure 11 on page 29.
Startup