Subaru H001SAN100 Instructions D'installation page 7

SYSTEM REGISTRATION
10
ENSURE SOFTWARE VERSION IS REVISION 18.1.1 OR NEWER (JULY 2019 UPDATE)
NOTE: Once the Ignition is turned ON, the system will exit System Registration after
2 minutes.
DST-i SETUP
Plug the DST-i
diagnostic plug
into the vehicle's
diagnostic connector
REGISTRATION
1. PRESS IMMOBILIZER ETC. REGISTRATION
AND PRESS SELECT
PRESS
3. PRESS G TYPE FOR KEY START MODELS
AND PRESS CONFIRMED
PART NUMBER ISSUE
H001SAN100
PRESS
PRESS
PRESS
DATE
00 26 Sept 2019
Plug the DST-i
USB plug into a
Network-Enabled
laptop
2. PRESS LEGACY AND PRESS SELECT
Insert an ignition key
into the ignition
cylinder and turn to
the ON position
4. ENSURE THE IGNITION IS TURNED ON AND
PRESS OK
WAIT FOR LAPTOP TO
ESTABLISH CONNECTION
SUBARU OF AMERICA
Select/Open the SSM4
software on the
Network-Enabled
laptop
PRESS
PRESS
PRESS
7 OF 10