Subaru H001SAN100 Instructions D'installation page 5

6
REMOTE ENGINE START ECU MOUNTING
1. Locate the factory mounting bracket/studs near the
upper left passenger's side glove box area.
(FIGURE K)
2. Using the two (2) supplied 10mm hex fl ange nuts,
secure the remote engine start ECU/bracket to the
factory bracket/studs, as shown. (FIGURE L)
3. Using a 10mm socket/torque wrench, tighten the 10mm
hex fl ange nuts to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2
Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
NOTE: Ensure the Remote Engine Start ECU
connectors will be facing forward, toward the
vehicle's dashwall.
4. Using two (2) of the supplied 39cm tie wraps, secure
the pre-arranged jumper harness to the vehicle's wire
harness above and below the pre-arranged harness
connections, as shown. Trim off the excess tie wraps.
(FIGURE M)
PART NUMBER ISSUE
H001SAN100
DATE
00 26 Sept 2019
Factory
Mounting
Bracket
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE K
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE L
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE M
SUBARU OF AMERICA
5 OF 10