Subaru H001SAN100 Instructions D'installation page 3

5
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate and release the vehicle's 2-pin power window
interrupt pre-fi t connectors secured to the vehicle's
wire harness with breakaway tape near the upper right
passenger's side glove box area. (FIGURE D)
2. When the vehicle's 2-pin power window interrupt pre-fi t
connectors are free from the breakaway tape, unplug
and discard the 2-pin mating connector/wire jumper.
(FIGURE E)
3. Plug the 2-pin power window interrupt pre-fi t connectors
together to complete the circuit. (FIGURE F)
4. Secure the 2-pin power window interrupt pre-fit
connectors to the vehicle's wire harness with one (1)
of the supplied 39cm tie wraps. Trim off the excess tie
wrap. (FIGURE G)
Glove Box Strut
FIGURE F
PART NUMBER ISSUE
H001SAN100
DATE
00 26 Sept 2019
Glove Box Strut
FIGURE D
Glove Box Strut
FIGURE E
Glove Box Strut
FIGURE G
SUBARU OF AMERICA
3 OF 10