Subaru H001SAN100 Instructions D'installation page 4

5
PRE-ARRANGED JUMPER HARNESS CONNECTIONS, continued
5. Locate and release the vehicle's 12-pin and 8-pin pre-
arranged harness connectors secured to the vehicle's
wire harness with breakaway tape near the upper left
passenger's side glove box area. (FIGURE H)
6. When the vehicle's 12-pin and 8-pin pre-arranged
harness connectors are free from the breakaway tape,
route the harnesses down through the opening in the
glove box inner cover. Plug the 12-pin and 8-pin pre-
arranged harness connectors into the remote engine
start jumper harness 12-pin and 8-pin connectors.
(FIGURE I)
7. Route the remote engine start harness back through
and behind the glove box inner cover. Plug the
remote engine start jumper harness 12-pin and 8-pin
connectors into the 12-pin and 8-pin white ports on the
remote engine start ECU. (FIGURE J)
ISSUE
PART NUMBER
H001SAN100
DATE
00
26 Sept 2019
NOTE: View with glove box inner cover removed.
(For illustration purposes only)
FIGURE H
FIGURE I
FIGURE J
SUBARU OF AMERICA
4 OF 10