Subaru H001SAN100 Instructions D'installation page 10

12
TRANSMITTER PROGRAMMING
1. Open the driver's door and enter the vehicle. The driver's door must remain open throughout the entire
programming process. Ensure all other vehicle doors, the engine hood and trunk are closed.
2. Verify that the transmission shifter is in the "park" position.
3. Turn the ignition "ON" then "OFF", "ON" then "OFF", "ON" then "OFF", then back "ON" and leave on throughout the
entire programming process. (ON/OFF ignition cycles must be completed within twenty (20) seconds.)
4. The system will fl ash the side marker lights, taillights and parking lights and honk the horn three (3) times
indicating that the system has entered transmitter learn mode.
5. Press and hold the
side marker lights, taillights and parking lights and honks the horn one (1) time, indicating that the system has
learned the transmitter. Release the
fl ash/beep one (1) time.
6. Repeat step fi ve (5) for additional transmitters. The system will accept up to eight (8) transmitters.
7. Turn the ignition OFF to exit transmitter learn mode.
8. Return to SECTION 11 to perform the POST INSTALLATION CHECKLIST.
NOTE: The system will exit the transmitter learn mode if the ignition is turned OFF, the driver's door is closed
or thirty (30) seconds of inactivity.
ISSUE
PART NUMBER
H001SAN100
button on the transmitter to be learned for three (3) seconds until the system fl ashes the
button. Upon successful programming, the remote start transmitter may
DATE
00
26 Sept 2019
SUBARU OF AMERICA
10 OF 10
4280854 Rev - 9/26/19