FilterMaster OSMOPOWER 2.0 Mode D'emploi page 8

Assembly
Two wall brackets are mounted to the module. Remove these from the module housing and screw them
onto a mounting plate or directly to the wall.
Now install the membrane.
Unscrew the filter cover from the membrane pressure housing using a filter key.
In order to do so, loosen the hose connection first:
1. Remove the blue securing ring.
2. Push down the white ring at the connector.
3. Now you can pull out the hose.
Remove the membrane from the plastic packaging and push it into the membrane pressure housing.
Ensure that the membrane is inserted into the housing in the flow direction. Push the membrane firmly
onto the ground before screwing on the cover of the container again. (The central tube of the membrane
8
must be at the same height as the container rim before the cover is screwed on again).
Attention:
For the first commissioning, flush the superfine prefilter and the activated carbon filter well before
reconnecting the hose to the membrane pressure housing!
For the reconnection, proceed in reverse order.
1. Push down the white ring at the connector
2. Insert the hose into the connector up to the stop.
3. Reinsert the securing ring.
4. Pull back the hose – to ensure that it is firmly seated.