Playing Back Tapes; Playing Back A Tape - JVC FS-L30 Manuel D'instructions

Playing Back Tapes

You can play back type I, type II, and type IV tapes without
changing any settings.

Playing Back a Tape

1
Press 0 PUSH OPEN on the unit.
2
Put a cassette in with the exposed part of the
tape down.
3
Press 0 PUSH OPEN again.
4
Press TAPE 2 3.
The unit automatically turns on and the tape
starts playing. The tape direction indicator
(3 or 2) flashes slowly on the display.
• Each time you press the button, the tape
direction changes.
3 :
plays the front side.
2 :
plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to
play both sides—Reverse Mode.")
If no cassette is inserted
"NO TAPE" appears on the display.
EN13-16_FS-L30[C]f
All manuals and user guides at all-guides.com
0
PUSH
OPEN
or . (See "To
16
To stop playing, press 7.
To fast-wind to the left or to the right, press ¢ or 4
while the tape is not running.
The tape direction indicator (3 or 2) starts flashing quickly
on the display.
To remove the cassette, press 0 PUSH OPEN on the unit.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE.
• Each time you press the button, reverse mode
changes as follows:
: The deck automatically stops after
playing both sides of the tape. Stops when
playback in the 2 direction is finished.
: The deck continues to play both sides of the
tape until 7 is pressed.
: The deck automatically stops after playing one
side of the tape.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
23
TAPE
TAPE
– 16 –
02.2.13, 3:48 PM
REV.MODE
REV. MODE