Dispensing Cold Water; Dispensing Hot Water; Rinsing, Cleaning And Draining - Royal Sovereign RWD-1750S Guide D'utilisation

DISPENSING COLD WATER

Water will take approximately 1 hour after initial set up to become completely chilled. The Cold indicator light will turn off
once the water has been fully chilled.
1. Use the cold water hands free paddle (right paddle). Press and hold to dispense cold water.
2. Release to stop dispensing.
DISPENSING ROOM TEMPERATURE WATER
1. Press and hold the hands free paddle (middle paddle) . Press and hold to dispense room temperature water.
2. Release to stop dispensing.

DISPENSING HOT WATER

Water will take approximately 1 hour after initial set up to reach the optimum hot temperature.
The Heat indicator light will turn off once the water has been heated.
1. Press the Child lock button, then press and hold the hands free paddle (left paddle) to dispense hot water.
2. Release to stop dispensing.

RINSING, CLEANING AND DRAINING

For best taste and unit performance, it is recommended that the unit be cleaned each time the water bottle is replaced.
Use a clean , soft cloth and mild dishwashing liquid. Empty and lean the drip trip as required. Clean the cold reservoir
at least once every 3 months.
DO NOT immerse the water dispenser in water. Avoid abrasive cleaning aids such as steel wool, Do not use bleach.
Before cleaning always unplug the water dispenser from the electrical power outlet.
To Clean the Outside of the Unit
Use a disinfectant such as a mild dishwashing liquid and warm water to wipe down the outside of the water dispenser.
INITIAL PRODUCT CLEANING PROCEDURE
Before cleaning, ensure that the unit is OFF and the unit is unplugged and the water dispenser on/off master switch
– 'O' position (#8)
1. Prepare in a small bucket about 3L (0.8 Gal) of room temperature water. (Diagram A)
2. Place the bucket inside cabinet door where the 3 or 5 gallon bottle of water would normally be placed.
3. Place the probe assembly into the bucket. (Diagram B)
4. Plug the water dispenser into an electrical outlet. Turn the water dispenser on/off master switch On (I) position Close the
cabinet door. (Diagram C) The pump of the water dispenser will begin to move water from the bottle to the water tanks.
5. Turn the Hot/Cold buttons ON (I) position (product overview #9,10). Allow 15-20 minutes for the water to heat/cool.
6. Turn the Hot/Cold buttons OFF (0) position (product overview #9,10). Remove the drain cap from the hot tank first
(Diagram D)
7. Wait unit the water stops flowing.
8. Place the drain cap back and ensure it is secure. (Diagram F) Repeat steps 6-8 for the Cold Water Tank. (Diagrams E & F)
9. Flush with about 2L of warm/hot water.
10. Repeat steps 6-9 for both the hot and cold water tank.
11. The water dispenser is now ready for use.
-6-