Royal Sovereign RWD-1750S Guide D'utilisation page 6

TURNING ON THE WATER DISPENSER
1. Plug the power adapter into a properly grounded wall outlet. The pump of the water dispenser will begin to move water
from the bottle to the water tanks. It will take a few minutes for the water tanks to fill for the first time. During this time,
the water dispenser pump will be running continuously.
2. Before turning on the Hot /Cold water switch (#9/10), ensure that water is already filled inside the water tanks by
dispensing a small drop of water from the hot, warm and cold water spouts.
Cold Water - Push the cold water switch (#9) to the ON (I) position
Hot Water - Push the hot water switch (#10) to the ON (I) position
Note: If you do not wish to have either the hot or cold water ON, you can leave the switch in the off (O) position.
Allow about 1 hour for the hot and cold water to reach the desired temperature. During this time the heat indicator light will
be on. The light will turn off when the heat process is complete. During this time the cold indicator light will be on. The light
will turn off with the cooling process is completed. If any error occurs during the process, the indicator light will blink.
REPLACING THE WATER BOTTLE
To replace the empty water bottle proceed as per below
1. Open the cabinet door
2. Slide the empty bottle from the cabinet
3. Remove the probe assembly (#6) from the empty bottle
4. Set the empty bottle to the side
5. Place a new bottle next to the cabinet door. Remove the entire plastic cap from the top of the bottle. Clean the outside
of the new bottle
6. Place the probe assembly (#6) into the bottle
7. Slide the collar down until it clicks in place
8. Push the head won until the tube hits the bottom of the bottle
9. Slide the bottle into the cabinet and close the door
EMPTY BOTTLE INDICATOR LIGHT
a) When there is water in both the hot and cold water tank, the Empty Bottle Indicator light will be Off
b) When the hot or cold water tank is empty, the Empty Bottle indicator light will flash
c) When there is water in the tank, but no water remains in the 3 or 5 gallon water bottle, the Empty Bottle
indicator light will be On and an alarm will sound for 30 seconds
d) When both the hot or cold water tank is empty and no water remains in the 3 or 5 gallon water bottle, the Empty
bottle indicator light will flash and an alarm will sound for 30 seonds.
e) In the rare event that the water tank is over flowing, the Empty Bottle incicator light will be off and an alarm will
sound for 1 minute
When the cabinet door is open, the water pump will not operate.
-5-