Royal Sovereign RWD-1750S Guide D'utilisation page 5

OPERATION
Unpacking
This water dispenser has been cleaned prior to packaging the unit . To remove any dust or debris that may have collected
during shipment, we however recommend cleaning the water dispenser prior to use. Refer to the Rinsing, Cleaning and
Draining section of this manual.
Locating the Water Dispenser
DO NOT PLUG IN THE POWER CORD OR TURN ON THE UNIT
Place the water dispenser upright on a flat surface. Position the water dispenser so that there is about 10cm
(4") of clearance from the wall on the back and on both sides
• Place the water dispenser in an area that is:
- Not humid and has a room temperature less than 26° (79°)
- Close to an electrical power outlet
- Away from the heat of direct sunlight and any heating appliance.
- Well ventilated and able to safely support the weight of the water dispenser with a 5 gallon bottle of water fitted.
- Dust and dirt free.
SET UP
Do not plug-in the water dispenser into an electrical outlet or turn on the unit until water has begun to dispense
from the hot, room and cold water spots. Failure to follow this warning may cause the water dispenser to
overheat.
Use a clean cloth to wipe the cap and shoulder of the 3 or 5 gallon bottle.
INSTALLING THE WATER BOTTLE INTO THE CABINET DOOR
1. Open the cabinet door
2. Place the probe assembly on the probe hanger
3. Place a 3 or 5 gallon bottle near the cabinet. Remove the entire plastic cap from the top of the bottle
4. Clean the outside of the new bottle with a cloth
5. Place the probe into the bottle (Product Overview #6)
6. Slide the collar down until it clicks in place.
7. Push the head down until the tube hits the bottom of the bottle
8. Slide the bottle into the cabinet and close the door
-4-