Publicité
Les langues disponibles
Les langues disponibles
4. Peel off the 3M liner from the Racing Stripe Graphic care-
fully, See Figure 1E. Spray adhesive side of the Racing
Stripe with the spray bottle and bring it into the correct
position on the vehicle. Align the center lines on the racing
stripe masking with the marks from Step 2. Ensure the
stripes are aligned with the features of the vehicle as shown
in Figure 1A and Figure 1C.
5. Remove water from under the Racing Stripe Graphic by
gently working the surface with the application squeegee.
Starting from the center of graphic, work upwards and
downwards away from the center of the Racing Stripe
Graphic. Then, from the center of the wet-out areas in step
4, work to the sides of the Graphics ensuring no air bubbles
remain under the Graphics. See Figure 1D.
6. Allow graphic to set approximately 10 minutes prior to
removing Masking.
NOTE: Remove masking by pulling it onto itself 180°.
NEVER pull straight up off graphic.
FIGURE 1A
FRONT PLACEMENT-COUPE & CONVERTIBLE
FASCIA
HOOD
A
Chevrolet Corvette Coupe/Convertible Racing Stripes
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
A
2
1
#
= SUGGESTED SEQUENCE OF INSTALLATION
REVISION
7. Once Racing Stripes are applied, cover the squeegee with a
soft cloth (comparable to 3M SA-1) and gently press any
bubbles out to the nearest edge of the Graphic.
NOTE: BE CAREFUL NOT TO SCRATCH OR MAR THE
GRAPHIC.
Allow 3 hours minimum at room temperature, 61°F-86°F
(16°C-31°C). for drying. Do not use the car wash for 48
hours.
If after application, bubbles of air are left in the decal/
graphic, pierce bubbles with safety pin on outer edge and
force air out with the squeegee. USE EXTREME CAUTION!
RACING STRIPES INSTALLATION SPECIAL NOTE
After being applied and pressed out, the edges of the film can
be peeled back, re-wet, and adjusted slightly, IF the water
below the graphic has not completely dried and the graphic
adhered to the vehicle.
THIS PROCESS IS VERY SENSITIVE - BE CAREFUL.
FIGURE 1B
REAR PLACEMENT-CONVERTIBLE
TONNEAU
MID
SECTION
REAR
DECK
LID
PART NO.
IR21JL08
INSTALLATION INSTRUCTIONS
AUTH
DR
TITLE
Coupe/Convertible Racing Stripes
PART NO.
19132171
6200 Grand Pointe Dr., Grand Blanc, MI 48439
5
4
3
B
B
19132171
SHEET
Chevrolet Corvette
3
SHEET
3
12
OF
12
OF
Publicité
