Luminance Brands kathy ireland HOME ASTOR Serie Mode D'emploi page 9

3. Ceiling Fan Assembly
3.9
While pulling up on the 4.5" Downrod, retighten the Two
Phillips Head Set Screws to secure the 4.5" Downrod in
the Motor Coupler (Figure 9).
NOTE: The Set Screws must be properly installed
as described above, or fan wobble could result.
WARNING
!
It is critical that the set screws in the motor coupler are
properly installed and securely tightened. Failure to
verify that the set screws are properly installed could
result in the fan falling.
3.10
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
4.5" Downrod until it rests on the Fan Motor Assembly
(Figure 10).
3.11
Place the Ceiling Cover over the 4.5" Downrod
(Figure 11).
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 11).
(Continued)
MOTOR
COUPLER
Figure 9
4.5" DOWNROD
GROMMET
COUPLER
COVER
Figure 10
Figure 11
9
RETIGHTEN TWO PHILLIPS
HEAD SET SCREWS
FAN MOTOR
ASSEMBLY
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF235