Luminance Brands kathy ireland HOME ASTOR Serie Mode D'emploi page 10

3. Ceiling Fan Assembly
3.12
Route the three Motor Wires through the Hanger Ball
(Figure 12).
Reinstall the Hanger Ball on the 4.5" Downrod as
follows:
Position the Pin through the Two Holes in the 4.5"
Downrod and align the Hanger Ball so the Pin is
captured in the Groove in the top of the Hanger Ball
(Figure 12).
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 12).
A loose Phillips Head Set Screw could create fan
wobble.
3.13
The Fan comes with Black, Blue and White Wires that
are 80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 13).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
(Continued)
PIN
HANGER BALL
4.5"
DOWNROD
Figure 12
6 TO 9
INCHES
1/2
INCH
Figure 13
10
SET SCREW
BLACK WIRE
BLUE WIRE
WHITE WIRE
HANGER BALL
ETL Model No.: CF235