Warning - Caution - Vortice C HCS Notice De Pose Et D'entretien

WARNING - CAUTION

!
Warning:
• Do not use this appliance for purposes other than
those described in this booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician
or Vortice*. Do not leave packaging within the reach
of children or the infirm.
• Certain fundamental rules must be observed when
using any electrical appliance, including: a) never
touch appliances with wet or damp hands; b) never
touch appliances while barefoot; c) do not allow
!
Caution:
this symbol indicates that care must be taken to avoid damaging your product
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Only use the appliance in the conditions indicated
by the manufacturer.
• Regularly inspect the appliance for visible defects.
If any faults are found, do not operate the appliance;
contact Vortice* immediately.
• If the appliance malfunctions or develops a fault,
contact Vortice* immediately. Ensure that only
genuine original Vortice spares are used for any
repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice*.
• The appliance must be installed and the fuse
changed if necessary by a professionally qualified
electrician only.
• Ensure that the electrical system to which the
(* Or an authorised Service Centre if you are outside the UK-Ireland territory)
12
this symbol indicates that care must be taken to avoid injury
children to touch or play with the appliance;
d) always ensure that infirm persons are supervised
when using the appliance.
• Store the appliance out of the reach of children and
infirm persons if you decide to disconnect it from
the power supply and no longer use it.
• Do not operate the appliance in the presence of
inflammable substances or vapours (alcohol,
insecticides, petrol, etc.).
appliance is connected complies with applicable
standards.
• The appliance must be connected to an earthed
power socket.
• Check that the electrical power supply/socket
provides the maximum electrical power required by
the appliance. If this is not the case, arrange for a
qualified electrician to make the necessary
modifications.
• Use a multi-polar switch with minimum contact gaps
of 3 mm to install the appliance.
• Switch off the appliance at the main switch: a) if the
appliance does not function correctly; b) before
cleaning the outside of the appliance, c) if the
appliance is not to be used for any length of time.
• This symbol indicates that the operation
must be carried out by a suitably
qualified person.
ENGLISH