Hydro Unit
Setting Function Codes for
Hydro Unit and Remote
Controller
Set function codes for various operation modes with
the remote controller.
There are two types of setting.
1) Hydro Unit function code setting
2) Remote controller function code setting
Setting remote controller mode
<Setting Hydro Unit Function Code>
1
Press the TEST
to enter the remote controller function code
setting mode.
2
Set the function code (CODE No.) with the
TEMP.
91)
3
Set data (DATA) with the TIME
buttons.
4
Press the SET
settings.
5
The CL
SET
button is pressed and the function
code is changed.
6
Press the TEST
settings.
<Setting Remote Controller Function Code>
1
Press the TEST
buttons for four seconds or more to enter
the remote controller function code setting
mode.
31-EN
+ SET
+ SELECT
buttons for four seconds or more
buttons. (CODE No.: 01 to
button to determine the
button is enabled only before the
button to end the
+ CL
+ TEMP.
2
Set the function code (CODE No.) with the
TEMP.
13)
3
Set data (DATA) with the TIME
buttons.
4
Press the SET
settings.
5
The CL
button is enabled only before the
SET
button is pressed and the function
code is changed.
6
Press the TEST
settings.
– 32 –
Installation Manual
buttons. (CODE No.: 01 to
button to determine the
button to end the