Table des Matières
Publicité
Rear Belt
Cover
Couvre-
courroie
arrière
Felt Packing
Cubierta
Cale en feutre
de la correa
Empaquetadura
trasera
de filtro
Motor Shaft
Arbre
d'entraînement
du moteur
Install New Belt
Eje del motor
+
Groove
Ouverture
Ranura
Replacing Belt
+
+
Lift Agitator Up
Soulever l'agitateur
Unidad del agitador
Poser la nouvelle courroie
Instalación de la correa
+
End Cap
Bouchon
Tapa del extremo
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
Remove lower plate.
Lift rear belt cover and remove felt
packing.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
Clean agitator.
Loop new belt (Type UB8 only)
around motor shaft and agitator
pulley; see illustration for correct belt
routing.
Reinstall agitator back into nozzle
housing grooves.
Close rear belt cover and reinstall felt
packing.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
- 32 -
Publicité
Table des Matières
