Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING:
Be extremely careful to maintain control of the
•
trimmer at all times. Do not allow the trimmer
to be deflected toward you or anyone in the
work vicinity. Failure to keep control of the
trimmer could result in serious injury to the
bystander and the operator.
Adjustment of the hanger position and shoulder
harness
014164
To change the hanger position, loosen the hex bolt on
the hanger with the supplied wrench. Then move the
hanger.
After adjusting the hanger position, tighten the hex bolt
with the wrench securely.
MAINTENANCE
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
attempting
to
maintenance on the trimmer. Failure to switch
off and remove the battery cartridge may result in
serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing the nylon cord
WARNING:
Make sure that the cover of the nylon cutting
•
head is secured to the housing properly as
described below. Failure to properly secure the
cover may cause the nylon cutting head to fly
apart resulting in serious personal injury.
Use only 2.0 - 3.0 mm (0.08" - 0.12") diameter
•
nylon cord. Never use metal wire, rope or the
like.
Use
of
recommended nylon cord may cause damage to
the trimmer and result in serious personal injury.
1. Hex bolt
1
perform
inspection
something
other
than
013822
Take off cover from housing, pressing two latches which
are slotted section oppositely on side of housing.
013823
Cut a nylon line in 3-6m (10 - 20 ft). Fold the cutting line
in two halves, leave one of half longer 80-100 mm (3 - 4
inches) than another.
or
013824
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2
channels provided for the nylon cord.
Wind both ends firmly around the spool in the direction
marked on the head for left hand direction indicated by
LH.
the
013825
Wind all but about 100 mm (4") of the cords, leaving the
ends temporarily hooked through a notch on the side of
the spool.
12
1. 80-100 mm
1
Publicité
Table des Matières
