Handlebar - SXT Scooters Raptor 1200 Mode D'emploi

a.1 FRONT WHEEL WITH DRUM BRAKE
The front end of the bike is attached to the
crate with a bolt which is the original axle.
Unscrew the nut carefully and remove the axle.
Locate the front wheel and insert the break
mechanism into it.
Insert the axle first in the swing arm of the front
fork and then in the break drum and the wheel.
Make sure to apply the spacer before inserting
the axle in the other side of the fork. Tighten
the nuts firmly.
a.2 FRONT WHEEL WITH DISK BREAK
Before installing the front wheel gently take
apart disk break pads using a wide flat
screwdriver, so the wheel disk can squeeze
between the pads. Push the speedometer black
cap against the wheel and position it in the way
that the axle bolt can go through it. Tighten
firmly the nut at the opposite side.
b) HANDLE BAR
Insert the top part of the handlebar into the
handlebar post as shown on the picture.
Locate the attachment bolt with the nut and the
spacer and insert the bolt in the hole from back
to front. Slide the spacer into the bolt with the
round side facing the handlebar post. Screw
the nut on top and tighten it. After attached,
the handlebar should look as on the picture on
the right.
6
GENERAL SAFETY GUIDELINES & RESTRICTIONS SXT-SCOOTERS