SXT Scooters Raptor 1200 Mode D'emploi page 11

BATTERY
BATTERY
BEFORE OPERATING YOUR NEW SCOOTER FOR THE FIRST TIME, CHARGE
THE BATTERY FOR 8-12 HOURS, BUT UNDER NO CIRCUMSTANCES IN EXCESS
OF 18 HOURS. Be sure to charge the E-SCOOTER after each use. Keeping
the battery properly charged will help extend the battery life. Do not use the
E-SCOOTER while the power indicator on the instrument panel shows low energy.
If the E-SCOOTER is over-used the battery's life will be reduced. The E-SCOOTER
uses a 60V (volt) battery pack. To charge the battery, connect the 3-pin plug into
the charging receptacle located directly below the front seat. The battery must be
charged while installed in the E-SCOOTER. If you notice anything unusual about
the battery such as a cracked or leaking battery case, a battery that gets hot
while being used or charged, a battery case that appears „puffy" or „bloated"
etc, or there are any other problems with the battery, please contact your local
dealer. The battery is sealed and is NOT user serviceable. Do not attempt to
repair, remove, adjust or in any way alter any internal or electrical components,
controls or wiring without first speaking with a customer service representative.
The main battery weights approximately thirty five (35) kgs. There are total five
(5) cells (12V20Ah/cell) connecting with wires. There is no need to remove it from
the E-SCOOTER unless you are replacing it. Use caution on removal. Proceed
to pull the battery out utilizing the handle. Disconnect the battery cable. The
E-SCOOTER is equipped with a 60V battery charger that will interrupt the char-
ging process once the battery has received a sufficient charge. Hereby strongly
suggests that the charger not be used in excess of 18 hours to prevent any unne-
cessary wear on the battery or charger itself. Charging for periods greater than
18hours may reduce the overall life expectancy and efficiency of these items.
9 3
BATTERY 9 SXT-SCOOTERS