LEM HEME ISO 1000 Manuel D'utilisation page 29

POWER ON functions
e) Defining additional memory locations/zones (HEME 2000)
Holding the key down on power up will display LOC (location). 32 site
STORE
locations are defined ranging from 00 to 31. Each location has a separate
save/recall screen memory area enabling screens to be saved in different
locations which can then be matched to various points in a building or plant for
ease of use and simple identification of stored readings.. The locations are
deliberately numbered from 0 upwards, as 0 is the default location. If the
separate memory facility is not used by not invoking this screen, all saved
screens go into the main memory of the default location.
The small digits showing the location (zone) number. Change the number with
the buttons (increment) and.
around between 0 and 31.
f) Delete Customer specific settings and return to factory defaults:
Press button
Turn the rotary switch from OFF to any measuring function.
The display shows: FS – Factory setting.
Confirming this display with the
stored settings. The instrument has the original default values stored again.
Turn the rotary switch to exit without setting factory defaults. Stored values in
memory are not cleared.
g) Continuous output
PC logging enabled. Hold down the
output displayed data. The instrument will send any valid measurements,
regardless of the rotary switch position to the RS232 interface. There is no
visual or audible acknowledgement that the instrument has entered this mode.
The display test continues as normal. Switch PC logging OFF by turning the
instrument OFF and ON.
Default values programming
decrement). The number wraps
(
button deletes all user parameters and all
key on power up to continually
SEND
- 28 -