Sentiotec Massivsauna BASIC LARGE Instructions De Montage page 4

Les langues disponibles

Assembly instructions

fig. 1.1

fig. 1.2

fig. 1.4

fig. 1.5

fig. 1.3

1. First place the right side and the back wall (part I lower

straight) next to each other, so that the screws can be seen on

the outside, as shown in fig.1.1. Screw the side to the back

wall. (screws 5x80)

Use the same procedure for the left side. The back wall is fixed

between both outer sides.

2. Now take the front log board with the opening for the door

and put the narrow right wall element onto it. (The element has

got a projecting batten on the right side at the bottom. fig.1.2)

Now screw the lower log board from the front to the batten

(screws 3x40 - fig.1.3) and on the side to the outside.

Use the same procedure for the left wall element. Now the sauna

cabin should look as in fig.1.4.

3. Check if the sauna cabin is at right angles by measuring

diagonally the length of both sides. (fig.1.5) The measurements

of both sides should be the same. ( +/- 2mm;)

Then check the sides with the spirit level if they are horizontal by

putting the spirit level on the upper edge of the side.