Safety Devices; Safety Information - Bartscher AB12/T-L Mode D'emploi

Safety devices

Microswitch: stops
when the grater lever is lifted. When
the lever is lowered, restart the
machine by pressing the I button.

Safety information

It is of the greatest importance to carefully read this manual before carrying out installation and use
x
operations. Consistent compliance with the instructions contained in this manual will guarantee personal
and machine safety.
Do not tamper with the safety devices for any reason.
x
We recommend that industrial safety regulations issued nationally by the appointed organisms be strictly
x
respected.
The manufacturer declines all responsability for injures to persons or damages to property, resulting from
x
failure to comply with these safety rules.
Correct machine setting, lighting and workshop cleanness are pre-conditions for personal safety.
x
Do not expose the machine to atmospheric agents.
x
The machine connection and start-up should only be executed by skilled engineers.
x
Check that the plant mains ratings correspond to the specifications printed on the machine data plate.
x
Make sure that the machine is connected to a grounding system.
x
The work area around the machine should always be kept clean and dry.
x
Wear the work attire prescribed by the industrial accident-prevention regulations.
x
This machine should always be used for its recommended uses ; any other use is deemed improper and
x
therefore dangerous.
Check the suitability and weight of the products to work ; do not overload the machine to exceed its
x
capacity.
It is forbidden to introduce any objects, tools or hands in the dangerous parts.
x
Keep the machine out of children' s reach.
x
Unplug the machine from the mains when not in use.
x
In the event of breakdowns and/or malfunctioning, do not carry out any repair yourselves, apply to your
x
Authorised dealer.
Order original spare parts only.
x
Before carrying out machine cleaning, unplug it from the power mains.
x
Do not clean with high-pressure water jets.
x
Translation of the original instructions
the machine
DANGER – CAUTION: Using plates with hole diameters over 8mm
and with total thickness under 5 mm is strictly prohibited.
Should wear cause plate thickness to drop under 5 mm, we recommend
you replace it. The manufacturer is not liable for any personal or property
damages due to failure to observe these instructions.
INFORMATION
Remote control switch: can be used
to restart the machine when the
electricity
accidentally.
For Grater mod.GR12/S only, when
the machine stops, the electronic board
intervenes to block the roller using the
motor brake.
7
1
GENERAL
supply is switched off