Table des Matières
Publicité
Canceling a period of temperature cutback
Temperature override
Change the temperature setting
(comfort or cutback)
Change the duration of temperature cutback
and/or the cutback temperature
x2
Permanently delete cutback function
Child lock
Hold down
and press once on
or
to override the current active
period, or the next period of tempera-
ture cutback. The lamp is lit steadily
for the period in question. Tempera-
ture cutback will resume as usual from
the subsequent period.
Selecting another temperature during
either a comfort or cutback period,
without storing it (by pressing
seconds), will apply only to the current
period.
When in the comfort or cutback
temperature mode, choose your new
comfort or cutback temperature by
pressing
or
.
Save the setting by pressing
than 5 seconds.
Hold down on
and press twice on
or
. Release
and h (hours) will
flash 3 times.
Using the
or
key select the
number of hours you want the cutback
to last.
Confirm by pressing
key briefly.
If you have first pressed
to change
the daytime cutback settings, d will
now flash three times and a random
number is displayed. Use the
key to select the correct day (Monday
= 1, etc.). Confirm by pressing
briefly.
°C will flash 3 times and then the cur-
rent cutback temperature will flash.
With
or
key select the cutback
temperature.
Confirm by pressing
key briefly.
To permanently delete a temperature
cutback function, press
or
the green lamp goes out.
To lock: Press
and
at the same
time until you see - - in the display.
To unlock: Press
and
at the same
time until you see - - disappear in the
display.
Calibration
20°C
for 5
more
20°C
Reset the thermostat to factory default values
Nb! Reset is not possible if the thermostat display is in any flashing
mode.
or
until
GB/AU
Should the actual room temperature
and Neo's setting not correspond, Neo
should be calibrated.
First let the heater work at the same
temperature setting, preferably for
at least 24 hours, keeping doors and
windows closed. This makes certain
that Neo that is regulating room tem-
perature.
Hold down on
and press once on
Release
. ºC will flash 3 times and
the setpoint temperature will flash.
Press
or
until the display shows
the same as the actual measured room
temperature. Store by pressing
5 seconds.
The heater will now work with the
temperature displayed by Neo and af-
ter a period this will correspond with
the actual temperature of the room.
This procedure can be repeated at a
later date to ensure correct calibration.
After resetting, the thermostat has to
be reprogrammed according to the
instructions for your chosen mode.
Switch the heater OFF.
Hold in the
key and then switch the
heater ON.
Hold the
key in for more than 5
seconds until rE starts flashing in the
display.
Release
and HO (Home Mode) will
flash.
You can select between modes HO, OF
(Office) and CA (Cabin) by pressing
the
or
keys.
Confirm your choice by pressing the
key for more than 5 seconds.
22 (°C) will flash. Select your pre-
ferred comfort temperature.
Confirm by pressing in the
key for
more than 5 seconds.
If you do nothing, 22 (°C) will auto-
matically be stored after 7 seconds.
for
25
Publicité
Table des Matières
