V-TAC VT-6056-4 Manuel D'instructions page 9

STEP 3. HANGING THE FAN BODY
• Notice the half ball on the end of the support rod is
grooved down one side (see figure 8). This Keyway
fits over the small keyway pin on the inside of the
mounting bracket and keeps the ceiling fan from
spinning on the mounting bracket.
• Using your step ladder, lift the fan and place the
half ball in the center of the mounting bracket with
the keyway pin inserted into the keyway on the ball.
Turn the fan left and right slightly to make sure it is
seated on the bracket with the keyway (see fig 9).
• Trim the lead wires, leaving about six inches of
each wire extending from the support rod (see fig 10)
FIG. 9
FIG. 8
FIG. 10
ENGLISH