V-TAC VT-6056-4 Manuel D'instructions page 8

• Thread the support rod into the support rod coupler until the safety pin can be inserted
through the hole in both the rod and coupler.
• Insert the safety screw through the hole in the support rod coupler and support rod then
attach the washer and retaining clip on the other side.
• Tighten both set screws and safety screw on the support road coupler.
• This fan is designed to be mounted as a flush mount (for lower ceiling heights), or suspended.
FLUSHMOUNT (SEE FIGURE 7)
Loosen the set screws (2) in the support rod
coupler located on top center of the motor
housing until the inside channel is clear.
Remove and save the safety screw from the
coupler.
Place the ceiling canopy on top of the motor
housing and secure with the three mounting
screws.
FIG.7
ENGLISH
SCREWS
CANOPY