V-TAC VT-6056-4 Manuel D'instructions page 16

STEP 8. FINAL CHECKS
• Check that all safety pins, set screws and connections are properly in place and tight.
• Check blade clearance and rotation.
• Attach the decorative pull chain tassel(s) to the switch housing.
• Located on the side of the switch housing is a slide switch. This switch controls the direction
of blade rotation. The UP position sets the blade in reverse rotation (air moves UP). The DOWN
position sets the blades in forward rotation (air moves DOWN). Make sure this switch is all the
way UP or DOWN, your fan will not run if it is in the middle.
• Illustrations in figures 20 and 21 show optional wiring diagrams that you can use.
FAN CONTROLLED WITH WALL SWITCH AND LIGHT CONTROLLED AT FAN
FAN CONTROLLED AT FAN WITH LIGHT CONTROLLED AT WALL SWITCH
FIG. 20
ONLY USE AN OPTIONAL WALL SWITCH THAT HAS BEEN DESIGNED FOR THE USE
WITH CEILING FAN
AND
FAN & LIGHT CONTROLLED BY WALL SWITCH OR SWITCHES
FIG. 21
ENGLISH