V-TAC VT-6056-4 Manuel D'instructions page 6

Install the mounting bracket to the electrical junction
box in the ceiling. Using two (2) machine screws, two
(2) washers, and two (2) lock washers (see figure 2).
Note: You may need a longer down rod to maintain
proper blade clearance when installing on a steep,
sloped ceiling (see figure 3).
The mounting bracket has slotted holes to enable it to
move sideways for proper alignment .Make sure the
mounting bracket is centered over the electrical junc-
tion box and that is securely attached (see figure 4).
SLOTTED HOLES
FIG. 4
NO MOVEMENT
SHOULD OCCUR
BETWEEN THE
MOUNTING
BRACKET AND
THE ELECTRICAL
JUNCTION BOX.
FIG. 2
JUNCTION BOX
HANGER OPENING
MUST BE FACING
UP-SIDE
FIG. 3
ENGLISH
JUNCTION BOX